SPARC Architecture Nasties

From gem5
Jump to: navigation, search

Ancillary State Registers

  • Floating-Point State Register (FSR) - holds 4 sets of condition codes, exception status, trap enable, rounding direction, etc. Which means we need to rename it, but we need to copy parts of the previous state into it every time.
  • Y Register - Why ohh why did the make this register. Holds upper 32 bits for some multiple/div operations. For multiply the upper 32 bits of the result is placed in here and the entire result is placed in the dest register. For some divides the upper 32 bits are read from here and then afterwards the state is unpredictable. Depending on how common these depricated operations are, we may be able to flush after each one instead of renaming the register.
  • Condition Code Register (CCR) - 8 bit register 4 bits for 64bit CC, 4 bits for 32bit CC. We'll have to rename them and in the case of sparc, they are all written at once so we don't have to rename some of them.
  • Address space identifies (ASI) - Distinguishes between different address space, what kind of translation is done, is the MMU used, also used to map control register for the processor. 255 ASIs 128 of which are unprivileged, the rest required privilidge or hyperpriviledge. Accessing a ASI you don't have privileges for results in a trap. ASI register is used when you issue a load/store alternate instruction. This could be preformance critical and we may want to rename it.
  • TICK Register - Counts Strand? Ticks, starting at 0 when the processor boots. Upper most bit controls if unprivileged software can read the bit. Make instruction that writes serializing?
  • Floating-Point Register State (FPRS) - enable/disable the FPU. serializing?
  • Performace Control Register (PCR) - don't implement?
  • Performance Instrumentation Conter (PIC) - don't implement?
  • General State Register (GSR) - holds info for VIS (SIMD) instructions. lower 32 bits flags and such, upper 32 bits set by BMASK instruction and used by BSHUFFLE instruction. Low bits can probably serialize on being written, may want to rename upper bits?
  • SOFTINT - read current interrupts, write to cause an software interrupt, two bits to enable/disable timer interrupts based of TICK register. Make writes serializing? Has two pseudo registers that writes to them either set or clear bits in the actually register.
  • Tick Compare (TICK_CMPR) - when lower 63 bits match lower 63 bits of TICK register level 14 interrupt occurs (if everything is enabled) bit 63 + SOFTINT.tim and PIL determine if interrupt actually happens. Writes serializing?
  • STICK,STICK_CMPR - same as tick, tick compare but synchornized across all processors.

Priviliged State Registers

Writes always serializing?

  • TPC[1..MAXTL] - PC from the previous trap level, written on trap, based on current TL only one readable.
  • TNPC[1..MAXTL] - NPC from the previous trap level, written on trap, based on current TL only one readable.
  • Trap State (TSTATE)[1..MAXTL] - various bits from registered copied in when a trap occurs. GL, CCR, ASI, PSTATE, and CWP.
  • Trap Type (TT)[1..MAXTL] - Specified what causes the trap, based on current TL only one readable.
  • Trap Base Address (TBA) - virtual address of the trap table.
  • Processor State (PSTATE) - Memory ordering model, address modes, another FPU enable bit, etc
  • TL - controls which of the above registers is accessed, values you can write into it dependent on current mode, autoincremented on trap
  • PIL - Like IPL on alpha
  • GL - chooses which set of global registers are enabled, values you can write into it dependent on current mode, autoincremented on trap
  • Hyperprivileged State (HPSTATE) - various little bits.
  • Hyperprivileged Trap State (HTSTATE) - like Trap state, but for the HPSTATE register
  • Hyperprivileged Interrupt Pending (HINTP) - if an STICK and HSTICK_CMPR are equal. (timer interrupt for Hypervisor).
  • Hyperpriviliged Trap Based Address ( HTBA) - same as TBA for HP state
  • Hyperpriviliged Implementation Version Register (HVER) - read only bits that describes the current version, manufacturer, MAXGL, MAXTL, MAXWIN.
  • Hyperpriviliged Tick Compare (HSTICK_CMPR) - like STICK CMPR for hyperprivileged code.

Instructions

  • CASA/CASXA - Compare and swap - IF: rs2 == MEM[rs1]: MEM[rs1][31..0] <-> rd[31..0]; rd[63..32] <- 0 ELSE: rd[31..0]<- MEM[rs1][31..0] ; rd[63..32] <- 0
  • FLUSH - make writes to program memory visable in the icache.
  • (LD|ST)TD - Load/Store twin double word instructions operate on 128bits loading/storing them from two adjacent registers in one atomic operation so you don't have to do any locking for a TLB update. yay.